The router NanoStation locoM5, High speed 5ghz MIMO is prepared for external and your WIFI antenna has a transmission speed of WIFI N 5GHZ with 150Mpbs MIMO download real and a range of more than 15km. With the technology of 2x2 MIMO uses the NanoStation locoM5, the links are significantly faster, and at a distance greater than with the CPE traditional. The NanoStation locoM5 has the necessary hardware so that it can be reset by PoE remote from the power supply. In addition, now, any NanoStation can easily become 802.3 af and run at 48V using the adapter Ubiquiti Instant 802.3 af. Technology integrated airMAX™ Protocol (TDMA-MIMO).
Ubiquiti Airmax NanoStation LOCO M5 5Ghz with Antenna 13dBi Dual-Polarization. This device only works in networks with a frequency of 5GHz exclusively , and not 2.4 GHz. It is used for data transmission to long-distance and high-speed. Must be installed by personnel with knowledge of this type of devices, the 5ghz Ubiquiti. Once installed it can connect to wifi routers normal or repeaters to the internet LAN.
New equipment for the exclusive use of the 5 GHz frequency. Currently, there are too many devices connected to the frequency band WIFI of 2.4 GHz, this causes interference which will affect the speed and the security of the connections. The band recently released the 5 GHz is less common and the systems of WiFi AC used this band for their transmissions. With fewer devices connected, you will have less interference and will reach higher speeds. Greater channel bandwidth. The old wireless connections had bands ranging from 20 MHz and 40 MHz. But with the new Wireless WiFi AC, the band has increased to 80 MHz, meaning a wider band for your data to pass insurance at a higher speed.
The new version 5 of AIROS Ubiquiti is based on the intuitive interface loaded with wireless configurations advanced and all the functionality of a router, plus a WIFI adapter with the functions of router client, router, repeater wifi, AP, receiver, wifi and wifi bridge.
Access Point AirMAX Ubiquiti M5 200mW 5Ghz 5.5 W 13dBi 32 MB SDRAM, 8 MB Flash
The new model for router Access Point UBIQUITI Loco M5 is a team that works in a way that is compatible with any product of other manufacturers, under the standard 802.11 N or TDMA-MIMO. It is the ideal solution for outdoor use thanks to its structure of protection for outdoors. Ideal for wireless links of more than 5KM
Dimensions: 163 x 31 x 80 mm
• Processor Atheros MIPS 24KC 400MHz
• Memory 32MB SDRAM and 8MB Flash
• Supports Power over Ethernet Passive
• It has a Ethernet port 10/100Mbps
• Resistant to water and heat outside.
• Antenna built-in 13dBi gain (5.475-5.825 GHz)
• Sweep wave, Horizontal: 45 °
• Vertical Polarization
• Includes Mounting Kit
• Power supply / PoE
• Speed adjustment
• Supports WPA, WPA2, TKIP, AES, WEP
• Supports filtering by MAC
• Supports different operation modes: Access Point, WDS, Client
• Operation temperature -40C to 85C
• Humidity 5 to 95%
• You can establish connections about 15km
• Setting Channels to 10/20/40 MHz
Network interface: 1 X 10/100 BASE-TX (Cat. 5, RJ-45) Ethernet Interface
Range: Up to 15Km depending on the WISP, % of and the environment.
Range/Throughput: Up To 150+Mbps @ 5+Km
Antenna: directional Antenna integrated 2X2 Mimo 8.5 dBi
Power supply: 24V 0.5 A injector included PoE Active
Type of supply: POE (pairs 4,5+; 7,8 return)
Working temperature: -20C to +70C
Weight: 0.2 kg
Nano Loco M5 is an access point that offers reliability and performance with a range of up to 15Km under Ideal conditions, 150 Mbps bandwidth, and an advanced and intuitive interface; AIROS Ubiquiti. The Access Point outdoor Ubiquiti NanoStation M5 Loco is perfectly compatible with the standard 802.11 N in 5.8 GHz. Includes everything needed for installation except the UTP network cable. Operates on a frequency between 5170 and 5875 Mhz WIFI AC. Spectacular performance a150 Mbps of actual speed and outdoor up to 5 km + range. With MIMO 2×2, the new M5 Loco Station links significantly faster and farther than ever before.
New antenna design
New series of antenna with a gain of 13dBi.
Designs of dual-polarity 5GHz.
Poe smart active
Remote Hardware for setting circuit. Allows the device to be reset remotely. In addition, any station loco M can easily become 802.3 af 48V compatible with the use of the adapter 802.3 af Ubiquiti.
• Processor: Atheros MIPS 24KC, 400MHz
• Memory: 32MB SDRAM, 8MB Flash
• Network Interface: 1 X 10/100 BASE-TX (Cat. 5, RJ-45) Ethernet Interface
• Weight: 0.18 kg
• Size: 163 x 31 x80
• Maximum power consumption: 5.5 watts
• Operation weather: -30C to 80C
• Operating about humidity: 5 to 95% humidity
• Power supply: 110-240VAC 15VDC 0.8 A US-style plug
FCC ID: SWX-M5LD IC: 6545A-M5LB
Rules > Wifi IEEE 802.11 a/n
Temp. Work Min > -30 ° C
Temp. Work Max > +75ºC
TX power mW Max > 200mW
TX power dBm Max > 23 dBm
RX sensitivity dBm > -95 dBm
Antenna Type > Panel
CPU > Atheros
CPU Speed > 400Mhz
CPU Architecture > MIPS 24KC
RAM > 32MB
10/100 Ethernet > 1-Port
Input voltage Max > 24VDC
ROM > 8MB
ROM Type > Flash
RoHS Consumption Max (Watts) > 5.5 Watts
Includes POE > If, 24V
Gain Antennas > 13 dBi
Frequency 5400Mhz / Frequency 5800Mhz
RAM Type > SDRAM
Polarization > Double
Beam Rf Elev. > 15th
Beam Rf H-pol > 45º
Beam Rf V-pol > 45º
Ubiquiti NanoStation LocoM5 CPE Indoor/Outdoor 5GHz
Ubiquiti Networks distributes the new CPE Customer Premises Equipment of low cost and high efficiency for links WIFI to long distance. The NanoStation LocoM5 with the integrated technology airMAX Protocol TDMA-MIMO.
Uses Technology airMAX
Unlike the protocol Wifi standard, the protocol of Multiple Access Time Division (TDMA) Ubiquiti airMAX allows each client to send and receive data using pre-assigned time slots scheduled by a controller of the access point AP smart.
This method of "time-spaces" removes nodes of collisions hidden and maximizes the efficiency of the connection. Provides many magnitudes of performance improvements in latency, flow rate, and scalability compared to all other systems outside of your class.
Intelligent QoS - priority Is given to voice/video for streaming seamless.
Scalability - High capacity and scalability.
Long Distance - Ability to high-speed links and a carrier class.
Latency Multiple Features which drastically reduce the noise.
Connectivity Dual Ethernet
The NanoStation M provides a secondary port of Ethernet with software enabled PoE output for seamless integration of IP video.
Remote hardware reset circuitry of NanoStation M allows the device to be remotely rebooted from the location of the source of power.
The NanoStation M can be powered by TOUGHSwitch PoE from Ubiquiti Networks. In addition, any NanoStation can easily become 48V, 802.3 af client through the use of the Adapter 802.Instant af Ubiquiti (sold separately).
Software NanoStation LocoM5 - AirOS
AirOS is the firmware intuitive, versatile, highly developed technology Ubiquiti. It is exceptionally intuitive and was designed in a way that requires no training to operate. Behind the user interface is a firmware powerful architecture, which enables high performance networks multipoint outdoor.
Adjustment of the Width of the Spectrum.
AirView nanoStation locoM5
Built-in products all Ubiquiti M, airView provides the functionality of the spectrum analyzer advanced: the views of the spectrum in cascade, waveform, and real-time, allowing operators to identify signatures of noise and plan their networks to minimize interference.
Cascade - Energy aggregated over time for each frequency.
Wave - Power aggregate that is collected.
Real-time - Energy-presented in real time as a function of frequency.
Recording - Enables AirView to record and report the results.
AirControl is a powerful and intuitive application for the management of networks, servers, web-based, which allows operators to centrally manage entire networks of devices Ubiquiti.
Map of Network.
Monitor status of Devices.
Firmware upgrade Mass.
Access Web UI.
Management of Groups of Devices.
Scheduling of Tasks.
This WIFI reflective parabolic disc is specially designed for the outdoor WIFI CPE of the brands Alfa and Ubiquiti models N2, N5, Ubiquiti Nano, Ubiquiti Loco
UBIQUITI NS-WM-mounting Kit Wall or Window For Nanostation NS2 and NS5This installation kit allows you to install the Nanostation both the wall and the window, in a solid form and safely.
We accept orders by the following methods:
Online (secure): browse our range and add products to your basket.
Offline: please see the contact us page for telephone, fax, and email details (you can change your country by clicking on the link at the top of the page). Shipping prices vary across our product range and can be viewed for each product on the product datasheet by choosing the country you are in.
Express international delivery & worldwide shipping.
All in-stock orders received Monday through Fridays are shipped the same day. For customers in Europe, the deadline for same day dispatch is 16:00pm. Orders received after these deadlines are shipped the next business day. You can check availability by viewing the datasheet which will display a yellow check mark if the product is in stock availability check mark.
Quality is important to Siliceo online Therefore if a product does not perform as described on the datasheet please notify us within 24 months of delivery using the contact form and our dedicated team of scientific experts will examine details of your protocol to determine whether the problem is protocol related or product related.
All payment details are described on the invoice that you will receive after your order is dispatched. The invoice will be sent to the billing address you specify and this can be different to the delivery address for the products.
We accept PayPal, credit card, cash on delivery, bank and wire transfer as methods of payment, for further details please contact us.