Filter By

Availability

Availability

Blog Search

USB TTL serial RS232 Serial

Cables adapters USB TTL to Serial COM port UART for Arduino PRO MINI Leonardo

There are several models available compatible with Arduino, with different chips, all with output UART cp2102 cp2104 PL2303 CH340 whose drivers are easy to download. All include support for up to windows vista, 7, windows 8 and successive.
The wires of the chip card adapter USB-to-TTL serial UART to create a virtual COM port and interface comunicaciópn to UART TTL, offer a power output to 5V and 3v, and 3.3 V, with up to 500 mA of current, allowing feed to other devices and even charge batteries. The built-in fuse to protect the usb port from surges of consumption eleéctrico. It can be used to program our arduino pro mini and to connect cualrquier device with the same communication protocol. The primary function of the chip UART TTL to handle the interrupts of the devices connected to the serial port to convert the data to parallel format. This mode transmits the data to the system bus, in serial format, so that they can be transmitted through the ports and vice versa.
UART comes from the English acronym for Universal Asynchronous Receiver-Transmitter / Receiver Transmitter Asynchronous Universal. Is used to control the ports and serial devices. A UART, dual, or DUART, combines two UARTs into a single chip. In the systems there is an electronic device responsible for generating the UART in each serial port. Most of the systems today use the chip 16550 UART, supports transfer rates up to 921,6 Kbps (Kilobits per second).

Utility to change firmware and debrick hard disk or router debrick firmware, reset factory and Arduino

The firmware on some hard drives Seagate (as the series Barracuda 7200.11 and the Momentus notebooks) have a defect that causes the disc to stop, and it stops to be detected system.
To solve this problem there is a need to upgrade the frimware of your hard disk conectandolo by Serial port using the pins GND / TX / RX converters chipset CP2102 / CP2104 incorporate drivers For all the systems, plus they have the advantage that it automatically converts the signal level to 3.3 V with the working of hard disk WRT160NL

The same procedure is used to debrick or change of firmware of the roter, DVD, satellite receiver, video game consoles, etc
Table of connection cables in the PINS
(PC) GND ↔ GND (Router, hard Disk)
(PC) Rx ↔ Tx (Router, hard Disk)
(PC) Tx ↔ Rx (Router, hard Disk)

Adapter converter cable USB-to-UART cp210x

Adapters, cables, and modules, converters Serial USB-to-TTL – UART (CP210x)
are designed to work in applications with serial port between PC and microcontroller, Arduino, PIC, Bluetooth, GPS etc
Converts any USB port into a serial port at TTL level with this handy adapter. Ideal to communicate with circuits on a provisional or definitive through a USB port, cp2102 and cp2104 are the chip Silabs more used to USB 2.0 module UART TTL 6 Pin converter series STC to replace the FT232.

With a fuse that prevents accidental short-circuiting. System that protegeel the computer USB port and downloader.
3 led: power on indicator, indicator, data reception, data transmission, and indicator of working status.
Power output with dual system: 3.3 V / 5 V
Cable pins for all kinds of designs.
Output of reset signal, etc. directly to the Arduino ProMini.
Operating systems driver download:
Windows 98/me/2000/xp/7/8/8.1/10
MAC OS-9
Mac OS 10
X-Windows CE
Linux 2.40 or later

Active filters