Temporarily out of stock - Write your Email here and click below, we will notify you when it is available
Warning: Last items in stock!
Interline HORIZON 868 HELIUM | 868 MHz LoRa Omni Antenna, Outdoor, 8dBi
Designed for IoT M2M (Machine to Machine) systems like Lora, LoRaWAN, Sigfox, XBee, RFID. Z-WAVE: HORIZON 868 HELIUM is a narrowband antenna, dedicated to the 868 MHz band with a gain of 8dbi which will allow long range coverage. It has a built-in bandpass filter. This limits interference from other transmitters working in neighboring radio bands, and in particular the GSM 900 / 4G 800MHz system, which transmits with high output powers. All frequencies outside of the antenna work band are shorted to ground.
Designed for IoT M2M (Machine to Machine) systems like Lora, LoRaWAN, Sigfox, XBee, RFID. Z-WAVE: HORIZON HELIUM is a narrowband antenna, dedicated to the 868 MHz band with a gain of 8dbi which will allow long range coverage. It has a built-in bandpass filter. This limits interference from other transmitters working in neighboring radio bands, and in particular the GSM 900 / 4G 800MHz system, which transmits with high output powers. All frequencies outside of the antenna work band are shorted to ground.
HORIZON HELIUM is a carefully designed and built omni-directional antenna operating in the unlicensed 867-870MHz band. Typical applications are monitoring and digital transmission of small amounts of data. Compared to the previous model of this antenna, the design of the radiator has changed. Silver-plated radiating elements were used (increasing the efficiency of the antenna).
The enclosure of the HORIZON antenna is made of heavy fiberglass. The robust, light weight and UV resistant construction is weatherproof (IP64 rating) which makes the antanna usable for in- and outdoor appliances.
The antenna is designed for mast/pole or wall handle installation. A mounting kit (angle bracket and u-clamp for 30-50mm diameter handles) is included.
Model: HORIZON HELIUM (IH-G08-F8688-V2)
Type of Antenna: Omni Antenna
Impedance: 50 Ohm
Frequency: 860 - 880 MHz
VSWR: max. 2.1
Polarisation: Vertical (Linear)
Beam width: 360° Horizontal
Connector: N female
Appliance: In- and Outdoor (IP64)
max. Windload: 160km/h
Dimensions: 80cm x 2.6cm
Operating Temperature: -40° to +80° C
Scope of delivery
1 x Interline HORIZON 868 Antenna
1 x Mounting kit with and u-clamp for 30-50mm handles
Fits the following miners:
Bobcat, Nebra, Sensecap, Cal-Chip, ClodPi, COTX Networks, Controllino, FreedomFi, Linxdot, Heltec, Kerlink, Long AP, Pisces, RAKWireless, Syncrobit
and other devices operating at this frequency.
For certain applications, such as urban environments or where large areas of terrain need to be monitored, the Horizon 8 Helium outdoor antenna will be the perfect addition to your Helium system. It is a solid solution that provides extra power and coverage for Helium outdoor base stations. The antenna has a medium gain of 8dBi, a length of 86cm, a frequency range of 868-880MHz, and comes complete with pole and wall mounting hardware.
In the new model, we have rebuilt the antenna radiator, modifying the radiation pattern, by changing the "phasing"antenna radiators.
It is a special antenna, with the main beam of radiation lowered (towards the ground) by 10 °, and suppressed undesirable upper lobes. This provides better coverage of the "area" under the antenna.
Helium LoraWan devices, working with commercially available broadband antennas, covering the EU868 and US915 MHz range.
These antennas also receive strong signals from GSM 900MHz transmitters, working in Europe with high powers.
This adversely affects the range and sensitivity of Helium-LoraWan devices, intermodulations may appear, especially near GSM antenna masts.
Our antenna has a built-in bandpass filter that works without attenuation in the working band of the antenna and is characterized by attenuation for other frequencies.
It is a specialized narrowband antenna operating in a dedicated band (EU868), which allows it to obtain a high signal-to-noise ratio (SNR) and maintain high sensitivity of the receiver in the device.
The range obtained on this antenna is even several dozen kilometers. The range depends on the mounting height, the type of Access Point, the quality of the antenna connector used (unit attenuation, length, quality of connectors), as well as the terrain and configuration of access points on the other side of the link.
In the construction of the heat sink, we do not use LC matching circuits (capacitance-inductance correlation) that allow for "artificial" antenna impedance adjustment and lowering the VSWR coefficient. This causes an increase in induction or capacitance which results in "blurring" of digital signals and has a negative impact on the bit / Hz encoding and the error rate (BER). Our antenna works "clean, resonant-resistive" and has a very low self-noise figure and an excellent bit / Hz encoding ratio.
The antenna housing is grounded, which protects it against electrostatic discharge
(electric charges appearing on the antenna are discharged to the earthing system)
For proper operation, the mast on which the antenna is mounted must be grounded to the existing lightning protection system.
This converter cable connector N to SMA RP-SMA is necessary for the connection of any WIFI adapter USB antenna long range type parabolic or yagi. With a length of 3 meters and quality of low-loss CF-200 allows you to reach all the networks and remote connections to several kilometers by the WIFI standard.
The cable pigtail cable TL-ANT200PT is ideal for flexible connections between cable/outside antenna and access points/wireless routers. It is very simple to use, does not require configuration or software installation.
We accept orders by the following methods:
Online (secure): browse our range and add products to your basket.
Offline: please see the contact us page for telephone, fax, and email details (you can change your country by clicking on the link at the top of the page). Shipping prices vary across our product range and can be viewed for each product on the product datasheet by choosing the country you are in.
Express international delivery & worldwide shipping.
All in-stock orders received Monday through Fridays are shipped the same day. For customers in Europe, the deadline for same day dispatch is 16:00pm. Orders received after these deadlines are shipped the next business day. You can check availability by viewing the datasheet which will display a yellow check mark if the product is in stock availability check mark.
Quality is important to Siliceo online Therefore if a product does not perform as described on the datasheet please notify us within 24 months of delivery using the contact form and our dedicated team of scientific experts will examine details of your protocol to determine whether the problem is protocol related or product related.
All payment details are described on the invoice that you will receive after your order is dispatched. The invoice will be sent to the billing address you specify and this can be different to the delivery address for the products.
We accept PayPal, credit card, cash on delivery, bank and wire transfer as methods of payment, for further details please contact us.