Outdoor antenna kit + indoor router to distribute Wifi from Ubiquiti NanoStation LocoM2. It can be used in camping, boat or caravan.
NanoStation LocoM2 CPE Panel Antenna, Long Range Router
Warning: Last items in stock!
The final Kit and the complete Wifi connection between two distant points. The CPE Ubiquiti Nanostation Loco M2 unit with its 8dBi Directional Panel antenna reaches more than 2 km away with direct view of each other. This complete kit has everything you need to take the Internet from one home to another, with direct vision. The distance does not matter as long as you have direct vision between this KIT and the WIFI network to link.
Ubiquiti products are designed for all those who want to interconnect two homes or premises and share data, Internet connection, etc. The high compatibility of these Ubiquiti devices makes them ideal in pairs.
The applications of this kit are:
• Communicate with the WIFI network of a local business with the particular home.
• Interconnects two private houses, two WIFI networks make premises or buildings of the same company or company.
The long-range NanoStation LocoM2 CPE panel antenna is designed for those users who need to connect to a remote network and share it with multiple computers, tablets, smartphones or Smart TVs, a KIT with cheap WIFI and easy to install. This package contains everything you need to install a waterproof panel antenna on the outside of the window or ceiling. The NanoStation Ubiquiti antenna is configured from any computer as a Client to receive the Wifi signal. Once configured, you can connect via network cable to the WAN port of this ultra-modern SILICEOUS Open-Wrt router. The router distributed internet throughout the house or building. Includes a 5 meter free cable, but supports cables up to 60 meters.
You can follow the diagram in the graphic for the installation of the entire KIT. The LOCO M2 NanoStation is positioned in a place from where it can receive the Wifi signal. It is waterproof and can be installed on the ceiling or in the window. Thanks to its wired network connection, and its active PoE feeder allows you to carry a cable of more than 60m to work, the Kit has a 5m free cable, which is sufficient for most cases. This device has an 8dbi antenna type built-in directional panel that must guide you to the area where the Wifi network signal comes from. To facilitate connection, a direct view should be sought between the NanoStation and the wireless network provider to link.
The NanoStation Ubiquiti is configured from any computer to connect to the wireless network you are looking for, using the CLIENT mode, available in this CPE, with this exploder all the WIFI networks available in the environment, and connects to the desired password.
The Open-Wrt repeater router is factory configured to repeat the Internet. If you want, you can change the name of the WIFI network and the password of the router. This router will create a new Wifi area with its own name, its own password.
The router with Open-Wrt has all the options of an advanced router with speed of 300Mbps and USB port with a multitude of possibilities, to share files, install USB devices and all the options of the advanced software Open-WRT wireless freedom
Network interface: 1 X 10/100 BASE-TX (Cat. 5, RJ-45) Ethernet interface
Range: up to 15 km depending on WISP and environmental interference.
Range / throughput: up to 150 + Mbps @ 5 + km
Antenna: Integrated 2X2 Mimo 8 dBi directional antenna
Power supply: 24V 0.5 A injector included PoE Active
Supply type: POE (pairs 4.5+; return 7.8)
Working temperature: -20C to + 70C
Ubiquiti Model NanoStation locoM ”FCC ID: SWX-M2L / IC: 6545ª-M2L
Features Dimensions: 163 x 31 x 80 mm
Operation mode: AP, Client, WDS
Frequency: 2400 - 2486 MHz
Transmission speed: up to 150 Mbps
WiFi standard: 802.11 b / g / n
Chipset: Atheros MIPS 24KC, 400Mhz
Max. output power: 23 dBm
Sensitivity: -96 dBm
Modulation: OFDM, DBPSK, DQPSK, CCK, 64QAM, 16QAM
Encryption: WEP, WPA, WPA2
Certifications: FCC, CE
LAN port: 1x RJ45 10/100 Mbps
Power supply: (passive PoE injector) 24 V, 0.5 A
Operating temperature: from -30 ° C to + 80 ° C
Interface: LAN, WiFI
Compatible Operating System: AirOS V
- Built-in antenna
Gain: 8 dBi
Polarization: linear - horizontal and vertical
H-pol beam width: 60 ° / 60 °
V-pol beamwidth: 60 ° / 60 °
Processor: MIPS 24KC, 400 MHz
NAND Flash: 8MB
Other characteristics -Range: up to 15 km
-Work band: 2.4GHz
Revision Date 05-29-2013 by JAV
Optimized design LocoM2 CPE 2.4 GHz for indoor or outdoor dual-use
Ubiquiti offers a CPE and an efficient NanoStation LocoM2 with integrated airMAX TDMA protocol technology and high-speed MIMO transmission. Using airMAX technology, which improves the standard of the Wifi system, the Ubiquiti airMAX Multiple Access Time Division (TDMA) protocol allows each client to send and receive data at maximum speed, with efficient driver access. The system avoids collisions and optimizes the efficiency of the connection. The firmware incorporates performance improvements in latency, flow rate, and scalability compared to other out-of-class systems.
Smart Airmax QoS: priority for voice or video transmission.
Nanostation long distance : Loco M2 to obtain a carrier class.
Improved with multiple latency: firmware to reduce noise.
WIFI antenna client with PoE Rj45:
NanoStation Ms feature a secondary Ethernet port with software enabled PoE output for seamless integration of cameras and IP devices.
With the PoE provider, NanoStation M's smart and remote hardware reset circuits allow you to reset the device by operating it from the location of the power source.
The NanoStation M can be powered on by the TOUGHS PoE Witch of Ubiquiti Networks .
This disk parabolic reflector WIFI is specially designed for CPE WIFI external marks Alpha and Ubiquiti modleos N2, N5, Ubiquiti Nano, Ubiquiti Loco
UBIQUITI NS-WM-mounting Kit Wall or Window For Nanostation NS2 and NS5This installation kit allows you to install the Nanostation both the wall and the window, in a solid form and safely.
Full router NanoStation loco M2. This CPE of the prestigious brand Ubiquiti combines all the functions of a WIFI antenna panel of long-range and a router. All integrated in a waterproof housing and with power cable RJ-45 with PoE adapter 24v. Scope guaranteed by the mark of more than 5km outside.
SILÍCEO presents the new USB repeater router for long-range WiFi antennas N519D chip RTL8811. The USB port of this new R658N router is compatible with 2.4ghz and 5ghz dual ban WiFi antennas that use Realtek RTL8811 or RTL811AU RTL8188 RTL8188RU chip > THE NEW> ROUTER R658U is version R658N
We accept orders by the following methods:
Online (secure): browse our range and add products to your basket.
Offline: please see the contact us page for telephone, fax, and email details (you can change your country by clicking on the link at the top of the page). Shipping prices vary across our product range and can be viewed for each product on the product datasheet by choosing the country you are in.
Express international delivery & worldwide shipping.
All in-stock orders received Monday through Fridays are shipped the same day. For customers in Europe, the deadline for same day dispatch is 16:00pm. Orders received after these deadlines are shipped the next business day. You can check availability by viewing the datasheet which will display a yellow check mark if the product is in stock availability check mark.
Quality is important to Siliceo online Therefore if a product does not perform as described on the datasheet please notify us within 24 months of delivery using the contact form and our dedicated team of scientific experts will examine details of your protocol to determine whether the problem is protocol related or product related.
All payment details are described on the invoice that you will receive after your order is dispatched. The invoice will be sent to the billing address you specify and this can be different to the delivery address for the products.
We accept PayPal, credit card, cash on delivery, bank and wire transfer as methods of payment, for further details please contact us.