Kit outdoor antenna + router interior to Distribute Wifi from Ubiquiti NanoStation LocoM2. Can be used on camping, boat or caravan.
CPE NanoStation LocoM2 Panel Antenna, long range router
Warning: Last items in stock!
The Kit final and full Wifi Connection between two distant points. The unit CPE Ubiquiti Nanostation Loco M2 with its antenna Panel directional 8dBi reach more than 2 km away with direct view to each other. This complete Kit has everything you need to carry the internet from one home to another, with direct vision. No matter the distance always that you have direct vision between this KIT and the WIFI network to bind.
Products Ubiquiti are designed for all those who want to interconnect two homes or premises and the sharing of data, Internet connection, etc., The high compatibility of these equipment Ubiquiti makes them ideal in pairs.
Applications of this kit are:
• Communicate with the WIFI network of a local business with the particular home
• Interconnect two private houses, two WIFI networks do premises or buildings of a same enterprise or company.
CPE NanoStation LocoM2 Panel Antenna long range it is designed for those users that need to connect to a network at a distance and share it with multiple computers, tablets, smart phones or Smart TV, a KIT with WIFI cheap and easy to install. This pack contains everything needed to install a panel antenna waterproof on the outside of the window or roof. The antenna NanoStation Ubiquiti is configured from any ordeadro as a Client to receive the Wifi signal. After configured you can connect by network cable to the WAN port of this router ultra-modern SILICEOUS Open-Wrt. The router distributed internet throughout the house or building. It includes a free cable of 5 meters, but supports cables up to 60 metres.
You can follow the outline of the graphic for the installation of the whole KIT. The NanoStation LOCO M2 is positioned in a place from which to be able to receive the Wifi signal. It is waterproof and can be installed on the roof or window. Thanks to its wired network connection, and your feeder active for PoE allows you to carry a cable of more than 60m to make it work, the Kit carries a free cable of 5m which is sufficient for most cases. This device has a built-in antenna type panel directional 8dbi which you have to guide towards the area of where the signal is coming from the Wifi network. To facilitate the connection must be to seek direct vision between the NanoStation and the wireless network provider to bind.
The NanoStation Ubiquiti is configured from any computer to link with the wireless network that you are looking for, using the CLIENT mode, available in this CPE, with this explñora all the WIFI networks available in the environment, and connects to the desired password.,
The router with Open-Wrt repeater comes configured from the factory to repeat the internet. If you want to you can change the name d ela WIFI network and the password for the router. This router will create a new Wifi area with your own name, your own password.
The router with Open-Wrt it has all the options of a router advanced with 300Mbps speed and USB port with a multitude of possibilities, to share files, install USB devices and all of the options of the advanced software Open-WRT wireless freedom
Network interface: 1 X 10/100 BASE-TX (Cat. 5, RJ-45) Ethernet Interface
Range: Up to 15Km depending on the WISP, and interference from the environment.
Range/Throughput: Up To 150+Mbps @ 5+Km
Antenna: directional Antenna integrated 2X2 Mimo 8 dBi
Power supply: 24V 0.5 A injector included PoE Active
Type of supply: POE (pairs 4,5+; 7,8 return)
Working temperature: -20C to +70C
Weight: 0.2 kg
Ubiquiti Model NanoStation locoM” FCC ID: SWX-M2L / IC: 6545ª-M2L
Features Dimensions: 163 x 31 x 80 mm
Weight: 180 g
Operation mode: AP, Client, WDS
Frequency: 2400 - 2486 MHz
Transmission speed: up to 150 Mbps
WiFi standard: 802.11 b/g/n
Chipset: Atheros MIPS 24KC, 400Mhz
Max. output power: 23 dBm
Sensitivity: -96 dBm
Modulation: OFDM, DBPSK, DQPSK, CCK, 64QAM,16QAM
Encryption: WEP, WPA, WPA2
Certifications: FCC, CE
LAN port: 1x RJ45 10/100 Mbps
Power supply: (PoE Injector Passive) 24 V, 0.5 A
Operating temperature: from -30°C up to +80°C
Interface: LAN, WiFI
Supported Operating system: AirOS V
- Built-In Antenna
Gain: 8 dBi
Polarization: Linear - horizontal and vertical
Width of Beam H-pol: 60°/60°
Beamwidth V-pol: 60°/60°
Processor: MIPS 24KC, 400 MHz
RAM: 32 MB
NAND Flash: 8 MB
Other Features -Range: Up To 15 Km
-Band work: 2.4 GHz
Revision date 29-05-2013 porJAV
LocoM2 CPE 2.4 GHz optimized Design for dual-use interior or exterior
Ubiquiti offers a CPE and efficient NanoStation LocoM2 with the integrated technology airMAX protocol TDMA and MIMO high-speed transmission. With technology airMAX, which improves the Wifi system standard, the protocol of Multiple Access Time Division (TDMA) Ubiquiti airMAX allows each client to send and receive data at maximum speed, with driver efficient access. The system avoids collisions and optimizes the efficiency of the connection. The firmware incorporates performance improvements in latency, flow rate, and scalability in comparison with other systems outside of your class.
Airmax Intelligent QoS: priority to voice or video streaming.
Nanostation long distance: Loco M2 to get a carrier class.
Improvement with latency multiple: firmware to reduce the noise.
WIFI antenna client with Rj45 PoE:
The NanoStation M's feature a secondary port of Ethernet with software enabled PoE output for seamless integration of cameras and IP devices.
With the provider of PoE Intelligent and remote hardware reset circuitry of NanoStation M allows for device restart handling it from the location of the source of power.
The NanoStation M can be switched on by the TOUGHS witch PoE from Ubiquiti Networks.
This disk parabolic reflector WIFI is specially designed for CPE WIFI external marks Alpha and Ubiquiti modleos N2, N5, Ubiquiti Nano, Ubiquiti Loco
UBIQUITI NS-WM-mounting Kit Wall or Window For Nanostation NS2 and NS5This installation kit allows you to install the Nanostation both the wall and the window, in a solid form and safely.
Full router NanoStation loco M2. This CPE of the prestigious brand Ubiquiti combines all the functions of a WIFI antenna panel of long-range and a router. All integrated in a waterproof housing and with power cable RJ-45 with PoE adapter 24v. Scope guaranteed by the mark of more than 5km outside.
We accept orders by the following methods:
Online (secure): browse our range and add products to your basket.
Offline: please see the contact us page for telephone, fax, and email details (you can change your country by clicking on the link at the top of the page). Shipping prices vary across our product range and can be viewed for each product on the product datasheet by choosing the country you are in.
Express international delivery & worldwide shipping.
All in-stock orders received Monday through Fridays are shipped the same day. For customers in Europe, the deadline for same day dispatch is 16:00pm. Orders received after these deadlines are shipped the next business day. You can check availability by viewing the datasheet which will display a yellow check mark if the product is in stock availability check mark.
Quality is important to Siliceo online Therefore if a product does not perform as described on the datasheet please notify us within 24 months of delivery using the contact form and our dedicated team of scientific experts will examine details of your protocol to determine whether the problem is protocol related or product related.
All payment details are described on the invoice that you will receive after your order is dispatched. The invoice will be sent to the billing address you specify and this can be different to the delivery address for the products.
We accept PayPal, credit card, cash on delivery, bank and wire transfer as methods of payment, for further details please contact us.