Arduino PRO MINI atmega328P with USB serial cp2102 TTL Kit cable

Arduino PRO MINI module Atmega328P 5v 16M compatible nano
High quality motherboard and processor ATMEL version 3.3 v / 5v 16M / 16mHZ

Pro Mini

This card is the miniature version of the Arduino Pro BAITE SILICON BT14-02, intended for applications in which the space is very small. Requires FTDI cable to be programmed and can fit into a breadboard if you weld pin spacing of 0.1 in. You can connect to a module USB-to-TTL. cp2102 SILICON-

USB 2.0 TO SERIAL RS232 UART TTL

CP2102 Compatible to Arduino Pro Mini

USB to UART Bridge

cp2102 module BTE13-007: DTR RXD TXD 5V CTS GND 3V RST SPD SPD/ RI DCD DSR RTS

Equal in size to the Arduino Mini, with the microcontroller ATmega328P-AU runs at 5V and 16Mhz, it also incorporates a reset button and the pins needed to connect a USB-serial adapter to be able to schedule it and nurture it. Also can be powered by an external source connected directly to the Vcc pin. This plate is designed to install semi-permanent or permanent in engineering projects.

Module Arduino PRO MINI 5V and 16 MHz. + adapter-compatible CP2102 CONVERTER USB 2.0 to TTL UART
The adapter CP2102 CONVERTER USB 2.0 to TTL UART is needed to program any Arduino board. (Arduino Pro Mini, Flora, Arduino Mini Light 05, etc), using chip CP2102 SILICON from Silicon Labs. This version is more advanced and works correctly without the need of soldering pins additional or press the Reset button on the Arduino Pro Mini.

The connection of the USB adapter SERIAL to the Arduino Pro Mini follows in this manual:

CP2102 --> Arduino Pro Mini
GND --> GND
RXI --> TX
TXD --> RX
DTR (GRN) --> GRN DTR VCC --> VCC

The móculo USB Series in conjunction with the Arduino Pro Mini allows to realize any project compatible
with the Arduino ONE at a price significantly lower than that, since the adapter is only used for programming
the Arduino board, becoming free after the schedule for other uses.

Allows to carry out projects at an affordable price and in a reduced size.

Arduino Pro Mini Compatible 5V and 16 MHz:

 Features. Microcontroller ATmega328 operating Voltage 5v input Voltage 5 - 12v - Pin digital I/O 14 (of which 6 provide PWM output) Pins of analog input 8 dc current per I/O 40 mA-Flash Memory 32KB (of which 2KB are reserved for the bootloader) SRAM 2 KB EEPROM 1 KB Clock Speed 16 MHz

It is a microcontroller board based ATmega328 (datasheet). It has 14 digital I/O (of which 6 can be used as PWM outputs), 6 analog inputs, an on-board resonator, a reset button and holes for mounting strips of pins. You can mount a strip of 6-pin connection to FTDI cable or breakout board to provide USB power and communication.

This intended for semi-permanent installation in objects or exhibitions. The board comes without mounted connectors, allowing the use of various types of connectors or soldered direct wires according to the needs of each particular project. The pin layout is compatible with the Arduino Mini.

Pro Mini 5V, 16M ATMEGA328

Dimensions: 0.7x1.3" (18x33mm) less than 2 grams

WINDOWS 98 / ME / 2000 / XP / 2003 / VISTA/Server
Server 2008 / Windows 7 / Windows 8 / windows 10 / 32-bit / 64-bit / Support LINUX / MAC

FULL SET COMPOSED BY:

1x BTE14-02 Pro Mini + Pin side

1 X Module USB TTL Serial cp2102